406-283-1106 • 406-396-6443
Bulldog Navigation

Bulldog Circuit Board Dowel Pin Puller

$475.00

This circuit board dowel pin puller is hand operated, lightweight, easy to use and can pull circuit board dowel pins from tooling boards in less than 5 seconds. In the past, dowel pins were “pried out” by a forked screw driver that is bent near the end in conjunction with a pair of vise grips.   The Bulldog will increase your productivity with less downtime between setups and totally eliminates tearing up circuit board tooling plates because of improper extraction with forked pry bars and vise grips.

Please enter collet size between .062"-.250". If unsure, just enter "unsure" in the Collet Size box and we will contact you to ensure exact sizing for your needs.

Description

This circuit board dowel pin puller tool provides over 500 pounds pull and bites on as little as .125-inch of the protruding pin. The Bulldog Pin Puller is truly an asset to any drill room.
This smaller pin puller comes in multiple sizes. Due to critical tolerances, one puller is needed for each size. We can meet your entire plate pulling needs from .062″ to .250″ diameter pins. Give us a measured pin diameter in the Collet Size box above (between .062″ to .250″), or send us a pin and we will custom-fit a tool to fit your needs.

Additional information

Weight 32 oz
Dimensions 12 × 7 × 5 in
Length

10"

Height

3.5"

Reviews

There are no reviews yet.

Be the first to review “Bulldog Circuit Board Dowel Pin Puller”

Your email address will not be published. Required fields are marked *